FEP

B9Creator - Ideas and Discussions
furlano
Newbie
Newbie
Posts: 3

FEP

Post#1 » Thu May 31, 2018 7:20 am

Anyone mind sharing where they get their FEP from and any installation suggestions? I had some samples but I am now out.

It seems to work for a while then the prints start sticking to the FEP and not the build table. Nothing changes but it just stops working.

I had to re-register under a different user name since I now use a new email.

Dan

User avatar
Metalcaster
B9 Wizard
B9 Wizard
Posts: 1285
Contact:

Re: FEP

Post#2 » Mon Jun 04, 2018 8:40 am

Hi Dan,
On my 2 machines, FEP works for a while... then I found that I had to manually increase the MSM by 50.. So, from .700 to .750 and it would print well again. No problems sticking to the platform. Before increasing MSM,problems I get would be in the heavier sections would tear apart.
other materials do print a lot better without any issues on FEP... but none of those are in a castable material at the moment.

furlano
Newbie
Newbie
Posts: 3

Re: FEP

Post#3 » Thu Jun 07, 2018 8:50 am

Thanks Dan,

I have been really struggling to get the printer to work consistently. I don't want to deal with PDMS any longer and I am at the point where I am starting to think I should just look into something else.

Dan

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 0 guests

Close Menu Shop Forum