Been a long time lurker over the years of ownership of my B9C v1.2 Machine. Learned a several helpful tips & tricks, however after several years of successful prints at 50microns with my machine running B9R–4–YELLOW, I have come across an issue.
My prints are starting to curl off the build table. I use Pre–PDMS applied vats from the B9 store, I am wondering if this issue is strictly a User Settings error? Should purchase the Stainless Build Table? Could it be that the base exposure time is too long? Or has the formula changed slightly in this newer batch of Yellow? I have only just started to notice this issue after starting a new bottle of Yellow.
I have attached some photos of my current Printer Settings & a photo of the problem after printing a model. Any info or comments are greatly appreciated!