1. In post #8 of this thread https://forum.b9c.com/viewtopic.php?f=22&t=4755&p=39181&hilit=custom+top+supports#p39181, Mike discusses how to add / modify supports tips. Basically, adding a sphere to the tip of the supports to make them easier to clip off without damaging the print.
May I suggest that y'all make this a part of the software? This would be handy.
2. I really like the the Peel Foundation. May I suggest that you make it rotate along with the stl, should I decide to spin the model?
Yeah, 1st world problems....