print sticking to duravat

- Operation
- Troubleshooting
kylerpiercings
Newbie
Newbie
Posts: 7

print sticking to duravat

Post#1 » Tue Feb 19, 2019 2:51 pm

So I'm getting prints stuck to both of my duravats in the same exact location on both units. Both of them are undamaged as far as I can see, and the build plate doesn't seem to have any damage. Any advice?

User avatar
akgold
B9 Wizard
B9 Wizard
Posts: 2067

Re: print sticking to duravat

Post#2 » Tue Feb 19, 2019 6:59 pm

Go to here submit a trouble ticket
http://www.b9c.com/support

in the mean time what resin and where both vats allowed to be exposed to the air with o resin covering the window membrane?
Last edited by mikej on Wed Feb 20, 2019 7:10 am, edited 1 time in total.
Reason: The duravat window is not pdms
I'm so far behind I think I'm First !!

kylerpiercings
Newbie
Newbie
Posts: 7

Re: print sticking to duravat

Post#3 » Tue Feb 19, 2019 9:49 pm

Hey! Thanks for your reply, yes, I did recharge the vats between cycles. I used both emerald and yellow

User avatar
Robert Howle
B9 Creator
B9 Creator
Posts: 6607

Re: print sticking to duravat

Post#4 » Wed Feb 20, 2019 1:23 am

Def contact support. Never seen this issue before.

Robert
Dance like nobody's watching!

Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 0 guests

Close Menu Shop Forum