Thank you, I will try to send it to you later today. These holes are only happening at the beginning of the prints on the flat surface. It then affects the next couple layers
in that area... Happens in a couple spots ... sometimes where you can't see it like on the inside edge /wall .
I have put it at an angle and the problem goes away.... but, because these are big pieces , the print time goes from 3 hours+ to 8 hrs+ and then I have a ton of supports on the bottom edge of the bracelets to remove.So Flat prints is the way I have to go at the moment.
I bring this up on the forum because I thought this problem was solved with a software update..... Could be my old age and failing memory
On my next one, I will try to increase the settle time and see if it makes a difference.