Quote from behold3d on November 26, 2014, 09:25
I'm confused. What was the result? Why didn't it meet your expectations? What machine are you using? What post cure process are you using? What cleaning method are you using?
Quote from RobertH on November 26, 2014, 15:40
yes do that, also if you could get the grid size laser cut on acrylic, so its more precise and doesnt bend for easier and more accurate caliberation, and I also use a loop to zoom in even more for the best focus. Start with 1.015 after that see what your results are and then if needed try 1.02 which I only do for big pieces.
Users browsing this forum: No registered users and 0 guests