Quote from Robert Howle on December 2, 2014, 22:22
We are doing test on the NuVat. After all info is in Mike should post user info. I think Evert will start selling then. This is my understanding as of now.
Robert
Actually Mike has already made his position clear on November 20th.
Mike's testing and results http://www.b9c.com/support/?mingleforumaction=viewtopic&t=2257.0#postid-23637
for small prints he says it could be ok but for larger prints he has his reservations but has no problem with Evert selling it.
Quote from mikej on November 20, 2014, 09:44
I'm OK with this product being sold, I'm giving Evert permission to do so. But I want his customers to be aware of the possible issues of "sticking" to the coating when printing large cross sectional parts. It's not the perfect pdms alternative, but the "no clouding" feature may make it very useful for certain situations.
I was gone from the 19th till the 28th so I couldn't post to the forum and have been playing catch up.
There is a new disclaimer based on the problem that Mike had with the glass releasing from his Vat during testing of the large object. apparently it actually pulled the glass plate off the vat spilling resin into projector. But read the thread and you will see that Mike said that the glass just needs a more permanent seal and or adhesion.
We are working on the disclaimer now but basically if your buy one it is at your risk and let it be known that this problem has happened once and could happen again.
http://www.b9c.com/support/?mingleforumaction=viewtopic&t=2257.0#postid-23637