Part of the build area doesn't print the base of supports

[DerekJackson]

One outer area of my build area refusing to print the base of supports below a certain point. I've attached a photo. Rest of the build area prints normally.

I've replaced the build tray, x-axis motor and projector lamp recently. Building on the 50micron settings.

Would love if anyone had any insight or solution to this. Its frustrating to have to strain the resin after each build.

[Robert Howle]

What machine which build table (stainless steel or original)?

Robert Howle

[DerekJackson]

B9 creator V1.2

Original Build Table.

[Robert Howle]

I recommend to everyone to get the new steel build table. Calibration is a breeze and eliminates one issue altogether.

Robert Howle