I ran into an issue where my supports seem to be warping (maybe from being 3" long and thin?) Or when growing something off a support, the resin was able to make the supports bend in some cases simply from the back and forth of the vat.
Anyhow, I went to recalibrate (factory settings as well) and noticed I cannot get the '-' to print on the 'F-' in calibration print. Everything else looks okay (though I have not measured with a caliper yet)
Here is a picture. Everything looks to be 'in focus' from my end and letters are nice and clear.
Which setting would be responsible for this? Added appreciation if you know why supports would bend