LEFT AND RIGHT PART

Any and all 3D Printing related topics
User avatar
ROSITAGIOIELLI
B9 Maker
B9 Maker
Posts: 334

LEFT AND RIGHT PART

Post#1 » Mon Jun 12, 2017 8:17 pm

right and left.jpg
right and left.jpg (121.81 KiB) Viewed 999 times

Immagine that after a print failure turning the table and look at the table as in the pic. and you note a lack, in your relative right part of the printed model on the table,so it means that you have to balance increasing the exposure time versus the left, so to the negative.
I wrote that because is it easy to made confusion. Especially when you do not have that in mind the calibration print as in the pic :D :D

Return to “3D Printing”

Who is online

Users browsing this forum: No registered users and 1 guest

cron
Close Menu Shop Forum