Yellow Resin & Settings

Any and all 3D Printing related topics
User avatar
Roxx
B9 Maker
B9 Maker
Posts: 38

Yellow Resin & Settings

Post#1 » Wed Mar 15, 2017 2:20 pm

I just started printing with the Yellow Resin. I feel like my prints are a little on the rough side. Any one have some knowledge or advice in the setting I might want to tweak to smooth things out?

Thanks,
Jon
Attachments
A031 - 20170315_135312.jpg
A030 - 20170315_135204.jpg
A029 - 20170315_135129.jpg

User avatar
Robert Howle
B9 Creator
B9 Creator
Posts: 6629

Re: Yellow Resin & Settings

Post#2 » Wed Mar 15, 2017 3:29 pm

When u swithch resins it's best to do a calibration print. Sometimes the MSM must be adjusted. Big help if u do one and post pics.

Robert Howle
Dance like nobody's watching!

User avatar
Roxx
B9 Maker
B9 Maker
Posts: 38

Re: Yellow Resin & Settings

Post#3 » Fri Mar 17, 2017 2:34 pm

Thanks Robert.

I will reprint a new one as soon as I get and install my new x-axis motor.

Not a good day yesterday. :(

User avatar
Robert Howle
B9 Creator
B9 Creator
Posts: 6629

Re: Yellow Resin & Settings

Post#4 » Fri Mar 17, 2017 4:08 pm

If u were already printing good calibraiton prints with another resin. Don't change your settings. You should only have to adjust the MSM. Most users find it has to be increased a small amount. Looks like under cured layers to me, or out of focus projector.

Robert Howle
Dance like nobody's watching!

User avatar
Roxx
B9 Maker
B9 Maker
Posts: 38

Re: Yellow Resin & Settings

Post#5 » Sat Mar 18, 2017 11:50 am

When the layers cure longer is harder to take the print off the build table? Taking the yellow resin off the table is much easier that the Cherry.

User avatar
Robert Howle
B9 Creator
B9 Creator
Posts: 6629

Re: Yellow Resin & Settings

Post#6 » Sat Mar 18, 2017 12:09 pm

May be an indication that the MSM should be raised.

Robert
Dance like nobody's watching!

Return to “3D Printing”

Who is online

Users browsing this forum: No registered users and 1 guest

Close Menu Shop Forum