Yellow Resin & Settings

[Roxx]

I just started printing with the Yellow Resin. I feel like my prints are a little on the rough side. Any one have some knowledge or advice in the setting I might want to tweak to smooth things out?

Thanks,
Jon

[Robert Howle]

When u swithch resins it's best to do a calibration print. Sometimes the MSM must be adjusted. Big help if u do one and post pics.

Robert Howle

[Roxx]

Thanks Robert.

I will reprint a new one as soon as I get and install my new x-axis motor.

Not a good day yesterday.

[Robert Howle]

If u were already printing good calibraiton prints with another resin. Don't change your settings. You should only have to adjust the MSM. Most users find it has to be increased a small amount. Looks like under cured layers to me, or out of focus projector.

Robert Howle

[Roxx]

When the layers cure longer is harder to take the print off the build table? Taking the yellow resin off the table is much easier that the Cherry.

[Robert Howle]

May be an indication that the MSM should be raised.

Robert