1/2 prints

Any and all 3D Printing related topics
User avatar
B9 Maker
B9 Maker
Posts: 38

1/2 prints

Post#1 » Sat Nov 12, 2016 9:18 pm

I have a couple of large prints that won't fit in the space for 30 microns. So I set the up my printer for 50 micron and calabrted the projector and build table. The first print was a pendant and it only printed half the file. The second time I printed the pendant it turned nice.
3rd print is a bracelet and it printed half way, then printed the top part. It's like it skipped 400-900 layers.
I reprinted the bracelet and again it only printed half the file. I notice at about layer 400 and the try table didn't seem to moving up. I paused the print and tried to manually move the try up and down. The table didn't manually move up and down but it did move vertical. I resumed the print and the tray went back and forth for 500 more cycles. The print table never advance upward.
Has anyone else had this problem?

Return to “3D Printing”

Who is online

Users browsing this forum: Bing [Bot] and 1 guest

Close Menu Shop Forum