I have a couple of large prints that won't fit in the space for 30 microns. So I set the up my printer for 50 micron and calabrted the projector and build table. The first print was a pendant and it only printed half the file. The second time I printed the pendant it turned nice.
3rd print is a bracelet and it printed half way, then printed the top part. It's like it skipped 400-900 layers.
I reprinted the bracelet and again it only printed half the file. I notice at about layer 400 and the try table didn't seem to moving up. I paused the print and tried to manually move the try up and down. The table didn't manually move up and down but it did move vertical. I resumed the print and the tray went back and forth for 500 more cycles. The print table never advance upward.
Has anyone else had this problem?