Hello! guys i need one more help for calibration.

[EPHO]

Thank you guys
I learned a lot from you guys.
I've been calibrate for 6 day over 30 test print.
And I corrected Z home 10400.

I learned I cant increase MSM over 1.150 in my case because of the damage of PDMS, however the middle square is always smaller than others.
the pic i upload was the last setting i tried and i tried all of different setting i can try.
But I couldnt solve the problem yet.
The top part kept not printed well and the bottom square is smaller than top part.
can you guys help me out please?

[EPHO]

Thank you guys
I learned a lot from you guys.
I've been calibrate for 6 day over 30 test print.
And I corrected Z home 10400.

I learned I cant increase MSM over 1.150 in my case because of the damage of PDMS, however the middle square is always smaller than others.
the pic i upload was the last setting i tried and i tried all of different setting i can try.
But I couldnt solve the problem yet.
The top part kept not printed well and the bottom square is smaller than top part.
can you guys help me out please?

middle square and the left bottom square is always smaller and the top part is almost good but still did not print well. I cant solve this problem with print setting. how can i change advanced setting? I decided not to touch anymore for the size of square but I need to solve the problem that F+ shape is not printed.
Please help me to use this printer.
I already used almost half of wax for the test.

[Robert Howle]

Move the B- and F- in the plus direction just a small amount.