Any idea what happened to this print?

Any and all 3D Printing related topics
austindecent@gmail.com
B9 Maker
B9 Maker
Posts: 16

Any idea what happened to this print?

Post#1 » Wed Oct 01, 2014 4:34 am

The White House model I was printing was fine for the first twenty minutes; then I came back and saw this. It looks like the layers stopped adhering after a certain point. Could it be the exposure time or a lift issue? I have had no problem with smaller models so far.
Image
Image

User avatar
mikej
B9 Moderator
B9 Moderator
Posts: 4190
Contact:

Any idea what happened to this print?

Post#2 » Wed Oct 01, 2014 5:08 am

Looks like it was perhaps over exposed (damaging the pdms) and started sticking to the pdms. What resin is that?
Measure Twice, Cut Once.

User avatar
behold3d
B9 Master
B9 Master
Posts: 535
Contact:

Any idea what happened to this print?

Post#3 » Wed Oct 01, 2014 5:13 am

unpigmented resin is usually harder to print with as pigment controls the depth of cure

austindecent@gmail.com
B9 Maker
B9 Maker
Posts: 16

Any idea what happened to this print?

Post#4 » Wed Oct 01, 2014 6:05 am

Its the Sub SF from Makerjuice. I've printed with their other clear resins. I cut the layer cure time down to 2 seconds so maybe it will work this time

Return to “3D Printing”

Who is online

Users browsing this forum: No registered users and 1 guest

Close Menu Shop Forum