X-motor turns without stop

- Operation
- Troubleshooting
Samuel Arredondo
B9 Maker
B9 Maker
Posts: 72

X-motor turns without stop

Post#1 » Mon Jun 03, 2019 9:38 am

Hello everyone,

I had to tighten the Gearbox attached on my X-motor because it went loose, but now as everything is reassembled the golden arm only turns around without stopping. When activating the left-right switch the arm doesn't stops at the half of the turn as usual but continues to move. Is my x-Motor broken, and if so where can I buy a new one ?

User avatar
akgold
B9 Wizard
B9 Wizard
Posts: 2063

Re: X-motor turns without stop

Post#2 » Mon Jun 03, 2019 12:38 pm

unplug the B9 remove the usb plug disconnect it from the computer turn off computer. wait for a couple of minutes then plug it all back in and restart the computer.
I'm so far behind I think I'm First !!

Samuel Arredondo
B9 Maker
B9 Maker
Posts: 72

Re: X-motor turns without stop

Post#3 » Wed Jun 05, 2019 10:39 am

Actually all I had to do is to let the printer refind the home position on the x-axis :oops:

Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 1 guest

Close Menu Shop Forum