error: failed to upload firmware

B9 Core Series - Ideas and Discussions
GuilhermeKB
Newbie
Newbie
Posts: 3

error: failed to upload firmware

Post#1 » Mon Apr 23, 2018 9:01 am

Good morning, I was printing normally, when the VAT axis went crazy from side to side, I could not get it to stop, so I took it out of the power outlet.

so I rebooted my computer, and the program B9creator does not recognize the machine, I have reinstalled all programs and I can not use my machine.

I already had a problem with this and I bought another PCB, and now it's the second time it happens, can anyone get a return?


----------------------------------------------------------------------------------------------------------------------------------------------------------------------

       System wide configuration file is "avrdude.conf"

         Using Port: COM5
         Using Programmer: arduino
         Overriding Baud Rate: 115200
avrdude: ser_open (): can not open device "\\. \ COM5": Access is denied.

18.04.23 11:56:49:77 Debug: B9FirmwareUpdate: Firmware Update FAILED, exit code: "1"
18.04.23 11:59:00 AM Debug: MessageMan: Message not sent, Master is true
18.04.23 11: 59: 00.702 Debug: Using Old Baud rate
18.04.23 11:59:04:70 Debug: MessageMan: Message not sent, Master is true
18.04.23 11: 59: 04.702 Debug: Neither Baud rate worked
18.04.23 11:59:08:70 Debug: MessageMan: Message not sent, Master is true

GuilhermeKB
Newbie
Newbie
Posts: 3

Re: error: failed to upload firmware

Post#2 » Tue Apr 24, 2018 8:20 am

How do I reload the firmware? into the plate?
it's possible?

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest

Close Menu Shop Forum