The problem of wave

[Robert Howle]

Worked for me for over 8 yrs.

Stl 2.JPG (25.3 KiB) Viewed 610 times

stl settings 2.JPG (55.92 KiB) Viewed 610 times

Make sure you uncheck the "Export open objects" box. If u check it, it allows for bad objects to be exported. You did have duplicate objects. I deleted everything from your file except the blue model (.3dm). Some of the stuff u sent in the file was already meshes.

Here are pictures of the mods to your file in CAD and my layout and print.

[akgold]

What setting are you printing the model on the 550 printer?

I have the 530 so not having the 550 I would imagine you would have to print the models on the lowest resolution
available and do as Robert shows with your mesh settings.

[Oiko_nemin]

Thank you very much, my problem has been resolved to a great extent. But as the last question, I see in the sample that you are printing lines that are in the final sample that I myself have printed. Is this the ultimate quality of the b9core550? I printed the rings file with Thickness of 30 and 50 , and there were two layers on it, how thick did you print the ring? Are these small lines normal or there is a way to get rid of them?

[Oiko_nemin]

The lines on the ring that I have printed are actually more and more visible than the file you printed, where is the problem with my work?

[akgold]

NOt sure it is a problem

The photos you saw from Robert is from the Core 530 and you are using a Core550.
There will be a difference in the surface detail.
The core 530 has a smaller build table and is able to print down to 20um even though we also print at 20um
I am not familiar with what the core550 looks like printing at 30 in comparison.

Fernando has a Core 550 so he would be better to address this as well as the
Crew from B9

[Oiko_nemin]

How can I connect with Fernando?

[akgold]

How can I connect with Fernando?

He should be monitoring this forum he's a dealer who sold you your 550???

[Robert Howle]

Contact Fernando at Red Door Distribution

https://www.reddoordistributions.com/