You have to understand that if u try printing on the Duravats without using the pre loaded settings u may damage a $995.00 vat. Using third party resins or even other B9 resins not already tested and loaded in the firmware will void the warranty on the vats. Do it at your own risk.
I don't think u should use the red or cherry or a mix because they have solid pigments (also avoid any resins with solid pigments or any that may stratify over a short period of time). There is no way to stir the resin in the vat while printing like with the B9 printers. There was a multiple reason for the lateral vat movement (layer release and mixing/stirring of the resin). I think it is a bad idea and should be avoided.
Last edited by Robert Howle
on Tue Feb 27, 2018 12:24 am, edited 1 time in total.
Dance like nobody's watching!