I wouldn't print it this way.
I would eliminate the bail on the cross and print snap it to floor print it flat on the table get rid of all those casting sprues on all of the items you show
All three of those stone settings can also snap to the floor as long as they were all set flat to planer before you made the STLs
if not then delete the sprues and print them at an angle about 10 up from the back on all of them.
Don't print your sprues to the items it is much better to use wax sprues to the items as the wax melts out and is eliminated allowing the ash form resin to evac much better.
I'm so far behind I think I'm First !!