This month I purchased my 550 and I am very happy with the ease of use on the machine. I picked the 550 because I was use to the 42 micron resolution I was getting with my other machine which was NOT plug and play. I figured there shouldnt be a huge difference because the other machine I was running had a 25 or 42 micron option and the difference between the two was very slight and almost not noticeable. But the 50 micron with certain pieces with higher detail such as a face or lettering is a huge difference. I’m familiar with reorienting the model to avoid build lines and have attempted that with the same consistent results. Here’s a pic of the build and I will attach the stl for any suggestions. Anyone know if B9 has an exchange program from a 550 to a 530?
Last edited by Mhgjewel
on Sun Jun 30, 2019 5:59 pm, edited 1 time in total.