So a couple days ago I had done a few prints that turned out great. This morning, however, when I went to slice a new job, the previous option of 24.5um had changed to just 25um.
I checked the other 2 machines I have the b9 software on, and they all had the same change.
The issue is that I have an original kickstarter machine, that has an upgraded 1.2 board on it (at least I'm pretty sure, assuming that the 1.1 boards were just like the originals, having an arduino with a shield, whereas this one is blue and a single board), and the previous slicing settings matched up to the steps of my z-screw.
Is there a way to change it back? If I recall correctly, the version I was running was 1.7.x, and we're currently on 1.8.6?
Is my only option to install an older version?