Page 1 of 1

Printing problems HELP NEEDED!!!!!!!

Posted: Thu Jul 06, 2017 8:28 pm
by romannysh@gmail.com
Hi guys,
I have a problem with my rings printing. I use B9 creator 1.2, cherry/red 1:1, 30xy x 50z. I print the same ring (same file), and the ring prongs on the upper side come out thinner than the same ring prongs on the bottom side of the build table. You can see that difference on the picture. I have calibrated my projector and built table a few times, changed two VAT's, but it didn't help. Any idea why it keep happening?
777.jpg

Re: Printing problems HELP NEEDED!!!!!!!

Posted: Thu Jul 06, 2017 9:17 pm
by akgold
Please just post it to one forum
we will see it as a new post you don't have to post it to all of them

Re: Printing problems HELP NEEDED!!!!!!!

Posted: Fri Jul 07, 2017 8:17 am
by Matt
Follow the fine tuning process here and that will allow you to even out the energy from the bulb across the build area. http://www.b9c.com/assets/media/files/documentation/b9-creator-projector-tuning-process.pdf

Re: Printing problems HELP NEEDED!!!!!!!

Posted: Fri Jul 07, 2017 9:02 am
by romannysh@gmail.com
Thank you very much! I will do that!