Printing problems HELP NEEDED!!!!!!!

- Installation
- Operation
- Troubleshooting
romannysh@gmail.com
B9 Maker
B9 Maker
Posts: 14

Printing problems HELP NEEDED!!!!!!!

Post#1 » Thu Jul 06, 2017 8:28 pm

Hi guys,
I have a problem with my rings printing. I use B9 creator 1.2, cherry/red 1:1, 30xy x 50z. I print the same ring (same file), and the ring prongs on the upper side come out thinner than the same ring prongs on the bottom side of the build table. You can see that difference on the picture. I have calibrated my projector and built table a few times, changed two VAT's, but it didn't help. Any idea why it keep happening?
777.jpg

User avatar
akgold
B9 Wizard
B9 Wizard
Posts: 2066

Re: Printing problems HELP NEEDED!!!!!!!

Post#2 » Thu Jul 06, 2017 9:17 pm

Please just post it to one forum
we will see it as a new post you don't have to post it to all of them
I'm so far behind I think I'm First !!

Matt
B9 Moderator
B9 Moderator
Posts: 147
Contact:

Re: Printing problems HELP NEEDED!!!!!!!

Post#3 » Fri Jul 07, 2017 8:17 am

Follow the fine tuning process here and that will allow you to even out the energy from the bulb across the build area. http://www.b9c.com/assets/media/files/documentation/b9-creator-projector-tuning-process.pdf

romannysh@gmail.com
B9 Maker
B9 Maker
Posts: 14

Re: Printing problems HELP NEEDED!!!!!!!

Post#4 » Fri Jul 07, 2017 9:02 am

Thank you very much! I will do that!

Return to “Software”

Who is online

Users browsing this forum: No registered users and 1 guest

Close Menu Shop Forum