Serious Settings Issue

- Installation
- Operation
- Troubleshooting
Lockermanjh
B9 Maker
B9 Maker
Posts: 23

Serious Settings Issue

Post#1 » Tue Nov 07, 2017 7:23 pm

Hello,
I've just begun having a strange issue with my printer (b9 v1.2). I was doing print calibrations, and my settings changes (MSM ect.) didn't seem to be effecting the following calibration print at all. I tested this theory by drastically changing the fade/balance/msm settings with no change in the resulting prints. I then closed out and disconnected everything, restarted my computer, checked for updates, restored the settings to factory default, and checked all the arduino connections. I am still having the same result.
Has anyone seen this before, any suggestions ?
Thanks,
- Jacob

User avatar
Robert Howle
B9 Creator
B9 Creator
Posts: 6565

Re: Serious Settings Issue

Post#2 » Thu Nov 09, 2017 1:27 am

Are u printing with a 3rd party resin or are u using custom settings for printing?

Robert
Dance like nobody's watching!

mikedajewla
B9 Maker
B9 Maker
Posts: 33
Contact:

Re: Serious Settings Issue

Post#3 » Tue Oct 16, 2018 1:22 pm

I turned my msm up to 2.0 and still the squares on the test pattern will not get to 5 mm. Did you fix your problem?

User avatar
mikej
B9 Moderator
B9 Moderator
Posts: 4171
Contact:

Re: Serious Settings Issue

Post#4 » Tue Oct 16, 2018 3:02 pm

Changing MSM will only affect the size a small amount, most of the size error comes from the overall image size not quite right (calibration of zoom).
Measure Twice, Cut Once.

Return to “Software”

Who is online

Users browsing this forum: No registered users and 1 guest

Close Menu Shop Forum