Hi guys a friend of mine who works in a lab doing cell research wanted me to print this file. Everytime i print it the 1mm gap in middle gets filled in...its for a microscope glass slide. Its very thin actually only lets me do 20 slice on it. here is stl any input would help https://ufile.io/lnkfa
its very small i know.. my friend wants to use it for measuring some samples. And if its thicker it wont fit on his slide it should be 1mm. Ak its 5 layers can u get it to print without filling..if you can what are your settings
I show it having 9 layers I printed it on my B9 core 530 @20
it printed I had to use a Razor blade to pull it off but damaged it a little on the corner. the line is there and it opened once I bent it slightly all it has is the line like if you pulled a razor blade across it. the curled pic. is right off the table. the flat one is after I put it in the B9 cure for 2min. I had to wet it and stick it to the bottom of the glass container and set it in there to get it to be flat. It is NOT 1mm .01mm maybe but it is there it isn't filled
it took 1.5min. to print in Green. Maybe yellow would work better I didn't try it on my 1.1 yet. tell us again exactly the dimensions is the line suppose to be 1mm or .1mm or .01 mm?