Layer separation

- Operation
- Troubleshooting
Zagloba
Newbie
Newbie
Posts: 3

Layer separation

Post#1 » Sun Apr 30, 2017 1:42 pm

Hi Everyone

I have a problem with my B9v1.1 after installing the booster kit at some point the print separate.
I try a other test this morning (6 Month later) with a new pdms but it still have the problem

Is anybody had a similar issue ?
Can we guide me to where i should look to solve this problem.
I would like to use this machine.

One other thing is that before the problem start i made a print for fun and it was a complete print exept i still have a (Zbanding) issue with the linear bearing upgrade.

Thanks

Zagloba
Attachments
IMG_20170430_150811.jpg
IMG_20170430_150355.jpg
IMG_20170430_150002.jpg
IMG_20170430_145934.jpg

User avatar
Robert Howle
B9 Creator
B9 Creator
Posts: 6612

Re: Layer separation

Post#2 » Sun Apr 30, 2017 6:50 pm

Are u using default settings for the resin u are using, how many lamp hrs. Have u done a test print since u did the upgrade. I would def do one to see it everthing is adjusted properly (zoom, focus, MSM, etc.)

Robert
Dance like nobody's watching!

User avatar
akgold
B9 Wizard
B9 Wizard
Posts: 2071

Re: Layer separation

Post#3 » Sun Apr 30, 2017 7:41 pm

Before you do anything Re-calibrate the build table to make sure it is correct. Then check your focus to make sure it is spot on.
then mess with the software settings.
Always check your hardware settings first before trying to compensate for possible Hardware malfunction.
I'm so far behind I think I'm First !!

Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 1 guest

Close Menu Shop Forum