Quote from Metalcaster on November 29, 2014, 12:42
Just a thought really.
Quote from Metalcaster on November 29, 2014, 14:10
If this got figured out, it may be possible to print on both sides of the vat during the same printing session... Not sure how much added software would be needed. I don't think any machine on the planet is doing that!:-)
If I had my machines set at 30,I would test it... I may try it a 50xy with just some small parts on it during next week and report back..
Quote from mikej on December 1, 2014, 11:12
I had originally tabled the random vat position idea because it doesn't work when you have a full build table (at low res). But I should revisit it, since many use less than the full build area. I'll bump up the priority on this.
Users browsing this forum: No registered users and 1 guest