This is the second time I have had this happen to my prints when using Mikes settings....not sure what's up. The prints are still a bit wet, but as you can see it's like they hit the event horizon in side the B9.
I'm not sure if it has anything to do with this post here..
@Robert, I'm on the 1.2. I'm going to reset my machine and enter Mikes info again then run another print now.
Software Version: Version 1.7.3 Copyright 2014 B9Creations, LLC www.b9creator.com
Last Comm Port: COM4
Display Index: 1
Last Print Attempt Status: Completed
Configuration: B9Creator v1.2.0, XY at 30 microns
Job Name: C:/Users/b9/Dropbox/stl/gard and morg.b9j
Name: gard and morg
XY Pixel Size: 30 µm
Slice Thickness: 30 µm
Total Layers: 1225
Material Volume: 3.51 ml
ID: 1:1 mix, Description: Hi-Res, lost wax suitable.
Calc Base: 3.532, Used Base: 1.6
Calc Over: 0.177, Used Over: 0.3
Calc Attach Layers: 2, Used Attach Layers: 2
Calc ABase: 14.128, Used ABase: 6
Calc AOver: 0.708, Used AOver: 1
Unsupported Pixel Multiplier: 0.8
Shutter Open Speed : 70
Shutter Close Speed : 60
Pre Exposure Delay (Settle) : 3
Post Exposure Delay (Kick) : 0.2
Post Release Delay (Breathe) : 1.5
Overlift Cutoff (mm) : 0.5
Initial Overlift (mm) : 3
Subsequent Overlift (mm) : 1.25
Dip (mm) : 0
X Offset: 0
Y Offset: 0
Show Grid: true