Quote from Metalcaster on November 26, 2014, 14:44
I am having the same problems with my 1.1 machine... all of a sudden bad builds. I will order the kit you specified ... looks like a good idea.
The machine does work with other material like MS material, but does not work well with B9 Cherry or Red.
Ok, so here is +1 to our bad company. Welcome :)
Any idea what could cause this?
For me too - MakerJuice resins works as usual, but B9R takes eternity to build some rings still with lack of quality on small details. I'm talking about 30-40z slice and 1:1 mix. Rings set about 30-40 mm height takes around 18-24 hours to print with stock printer settings except significantly increased cure times. But still I can't get good prongs on top of the rings. Of course calibrated projector in terms of xy plane and "hot spot". The same to build table. Few different PDMS'es, and resin from different bottles.
And that's on the freshly changed lamp - 200+ hours now on it.
Also I noticed that PDMS life with B9R now is significantly shorted, likely due to hugely increased exposure. I can see fogginess after ONE print.
I'm desperate to try even removing of UV filter, like NOEHBERN did. He now prints at 5x times faster speed!