V1.2 First layer after supports bowed/Pillowed

A lost wax capable resin tuned for 30 - 50 micron slice thickness
gopack
B9 Maker
B9 Maker
Posts: 10

V1.2 First layer after supports bowed/Pillowed

Post#1 » Mon Dec 15, 2014 1:16 pm

So, I am able to successfully print using 100% Cherry B9R1. However, the first few layers of the part have a slight "bow"/"pillow" to them around the supports. I am guessing I need to add more supports (I already have quite a few). It looks that when the table presses down after the first layer of the part has been formed the cherry resin fills it up like a pillow and causes this phenomenon. I am using the default Cherry Settings and it is really hard to take a picture of the problem so I did my best. You notice daylight under the part, it should be flat based on the CAD model. The top surface looks perfectly flat and smooth. Thanks!
Attachments
WIN_20141215_151331.JPG

Return to “B9R-1-Cherry”

Who is online

Users browsing this forum: No registered users and 1 guest

Close Menu Shop Forum