Sometimes it's all about orientation

Successful prints based on Model construction, supports, material selection & printer settings.
User avatar
Robert Howle
B9 Creator
B9 Creator
Posts: 6622

Sometimes it's all about orientation

Post#1 » Sun Feb 19, 2017 3:15 am

Just an example of print that is best laid on the side. Byzantine chain ring. Printed for another store.

1 hr and 10 min on 1.2 at 30xy and 30 z. Emerald resin. Not cured yet. Just cleaned in the ultrasonic after sloshing in Dawn and water mix.

Byzantine ring 1.jpg

Byzantine ring 2.jpg


Robert Howle
Dance like nobody's watching!

User avatar
panastation
B9 Maker
B9 Maker
Posts: 329

Re: Sometimes it's all about orientation

Post#2 » Mon Feb 20, 2017 8:06 pm

cool
emerald is my favorite resin so far. Are you still microwaving models in oil :?:

User avatar
akgold
B9 Wizard
B9 Wizard
Posts: 2086

Re: Sometimes it's all about orientation

Post#3 » Mon Feb 20, 2017 8:23 pm

That is a cool design and seeing it grown is just one of those rings where people look at it and say
You can do that here?
Good job.
I'm so far behind I think I'm First !!

Return to “Tips & Tricks”

Who is online

Users browsing this forum: No registered users and 1 guest

Close Menu Shop Forum