z-axis setting/measurement

Using the software
abus
Newbie
Newbie
Posts: 2

z-axis setting/measurement

Post#1 » Fri Jul 28, 2017 4:03 am

Hello people,

i'm currently doing some experiments with the b9 v1.2, frickeling around with different admixtures to the original resin. The hardend resin/addon-mixtures don't stick to the original build table. Therefore I try different materials as buildtable. I attach them underneath the original buildtable (the thickness being aprox. 5-6 mm). Thus I need to measure and adjust the z0 position, because the buildtable can't go that far down as it used to.

Is this possible and how can i do that?

Can the b9 creator itself measure z0, e.g. during buildtable configuration, does it notice when it hits the bottom and resets z0?

Cheers & thanks a lot,
Alex


P.S. the attached picture shows my "buildtable setting".
Attachments
buildtablemitunterlage.jpg

User avatar
Robert Howle
B9 Creator
B9 Creator
Posts: 6601

Re: z-axis setting/measurement

Post#2 » Tue Aug 01, 2017 1:10 am

If your mixtures are not sticking then u need longer exposures for the attachment layers, u should not need to change the surface of the build table.
Dance like nobody's watching!

Return to “Operation”

Who is online

Users browsing this forum: No registered users and 1 guest

Close Menu Shop Forum