i'm currently doing some experiments with the b9 v1.2, frickeling around with different admixtures to the original resin. The hardend resin/addon-mixtures don't stick to the original build table. Therefore I try different materials as buildtable. I attach them underneath the original buildtable (the thickness being aprox. 5-6 mm). Thus I need to measure and adjust the z0 position, because the buildtable can't go that far down as it used to.
Is this possible and how can i do that?
Can the b9 creator itself measure z0, e.g. during buildtable configuration, does it notice when it hits the bottom and resets z0?
Cheers & thanks a lot,
P.S. the attached picture shows my "buildtable setting".