perpetual_dreamer wrote:yes, the slicing speeds are super fast. Surprised me when it took about 20 seconds to slice a file. It usually takes 3 mins or so.
Print is done and it came out all good.
I'm still confused about this note on the print panel "Caution: Standard Print Cycle Settings Not Utilized"
Should I select and ask it to use the default the Red/Cherry 30zxy default settings next time?
mikej wrote:Yes, go ahead and click to restore defaults if it comes up.
Matt wrote:The squares should measure 5x5mm. F+ and F- sides should be 90mm spanning from left square to right square. B+ and B- sides should be 50mm spanning from from top square to bottom square. *for 50 microns
mikej wrote:The z bleed correction will not make z bleed worse on small parts, but it may cause very small details to fail. This is because they are too small to survive the printing process at the correct size. The old software allowed z-bleed to enlarge them enough that they would print. But that could also be done by enlarging them in the original design.
Users browsing this forum: No registered users and 1 guest