Page 1 of 1

Grid is projected out 2 mm

Posted: Tue Sep 29, 2015 9:22 am
by joyas3d
Hello.

I calibrated my machine and I see that loses 2 mm on the left. it seems that the calibration grid is projected out 2 mm

Thanks a lot for the help.

Re: Grid is projected out 2 mm

Posted: Tue Sep 29, 2015 9:42 am
by Matt
This seems to be an issue on the computer side, simply hit the "Auto" button on the projector and it will force it into the proper place. You may have to do this again if you disconnect your video cable. Also you can try using a different source input like hdmi instead of vga or vice versa.

Re: Grid is projected out 2 mm

Posted: Tue Sep 29, 2015 9:48 am
by joyas3d
Matt wrote:This seems to be an issue on the computer side, simply hit the "Auto" button on the projector and it will force it into the proper place. You may have to do this again if you disconnect your video cable. Also you can try using a different source input like hdmi instead of vga or vice versa.



Hello.

Thank you very much for the reply, I will try.

Re: Grid is projected out 2 mm

Posted: Tue Sep 29, 2015 11:03 am
by joyas3d
Hola.

The auto function edited and the grid is centered.

Muchas gracias seƱor Matt