Page 1 of 1

Feature Request - Pause For Inspection

Posted: Tue Sep 29, 2015 7:04 am
by EM
When working through a problem, it would be nice if the software would pause the printing automatically:

  • Setting allows you to specify printing to pause at layer X or every multiple of X, i.e. X=5.
  • After layer 5 prints, the build table raises to the height it normally does when a job is finished.
  • Projector state? - I'm not sure of the best setting to minimize wear and tear on the bulb, but assume that printing will resume in 5 to 10 minutes.
  • After inspecting the build table and vat, user clicks the resume button.
  • Dialog prompts user to confirm that build table and sweeper are installed.
  • Printing resumes. If 'every multiple of x' is selected, the the print pauses after layer 10 and the process repeats.