Basic Requirement Of Computer

Using the software
selvab9
B9 Maker
B9 Maker
Posts: 23
Contact:

Basic Requirement Of Computer

Post#1 » Mon Feb 16, 2015 5:50 am

I would like to know basic Requirement Of Computer for operating B9 1.2 ,I tried with many type of PC really not found something yet.Specifically any graphics card or VGA cable have to use?
selva

selvab9
B9 Maker
B9 Maker
Posts: 23
Contact:

Re: Basic Requirement Of Computer

Post#2 » Tue Feb 17, 2015 12:01 am

i have tried B9 1.2 test print with supplier PC, out put came out well i am trying many time same & different setting in my PC out put came as attached images , is this any input problem or PC problem? build table calibration and projector calibration did properly,


SETTING
Software Version: Version 1.7.3 Copyright 2014 B9Creations, LLC www.b9creator.com

Last Comm Port: COM3
Display Index: 1
Last Print Attempt Status: Completed
Configuration: B9Creator v1.2.0, XY at 30 microns
Job Name: C:/Users/test/Desktop/16-2-2015-2.b9j
Job Data
Name: 16-2-2015-2
XY Pixel Size: 30 µm
Slice Thickness: 30 µm
Total Layers: 159
Material Volume: 0.24 ml

Material Settings
ID: B9R-1-Cherry, Description: Hi-Res, lost wax suitable.
Calc Base: 3.56, Used Base: 3.56
Calc Over: 0.178, Used Over: 0.178
Calc Attach Layers: 2, Used Attach Layers: 2
Calc ABase: 14.24, Used ABase: 14.24
Calc AOver: 0.712, Used AOver: 0.712

Cycle Settings
Unsupported Pixel Multiplier: 1
Shutter Open Speed : 80
Shutter Close Speed : 80
Pre Exposure Delay (Settle) : 1
Post Exposure Delay (Kick) : 1
Post Release Delay (Breathe) : 1
Overlift Cutoff (mm) : 3
Initial Overlift (mm) : 1
Subsequent Overlift (mm) : 0.1
Dip (mm) : 0

Job Position
X Offset: 0
Y Offset: 0
Mirrored: false
Show Grid: true
Attachments
PC.JPG
DSCN2584.JPG
DSCN2584.JPG (103.72 KiB) Viewed 1136 times
Capture.JPG
1.PNG
selva

jimbit22
B9 Maker
B9 Maker
Posts: 27

Re: Basic Requirement Of Computer

Post#3 » Tue Feb 17, 2015 2:13 am

You can try increasing the machine specific multiplyer under printer specific settings by a factor of 0.1 and try printing again.
Always ensure that your resin is properly mixed.. i dont think that is a computer issue.

Return to “Operation”

Who is online

Users browsing this forum: No registered users and 1 guest

cron
Close Menu Shop Forum