Calibrating with the new heavier build table

Discussions on normal hardware operation, tips, etc.
User avatar
Robert Howle
B9 Creator
B9 Creator
Posts: 6620

Calibrating with the new heavier build table

Post#1 » Tue Jan 31, 2017 1:48 am

Had the issue come up with a new user. Was haveing problems with prints ripping off the build table. After some discussion the user had pressed down on the new buid table. The stainless steel buid table is heavy enough that the weight of the table is all u need for proper calibration. When the screws are loose, and u have a free floating table, then all u need is a good PDMS and tightening the screws.

Robert Howle
Dance like nobody's watching!

Return to “Operation”

Who is online

Users browsing this forum: No registered users and 1 guest

cron
Close Menu Shop Forum