Extreme Balance, Fade, Slope, MSM conditions

Discussions on normal hardware operation, tips, etc.
Bilal
B9 Maker
B9 Maker
Posts: 23

Extreme Balance, Fade, Slope, MSM conditions

Post#1 » Sat Dec 03, 2016 7:35 am

Hello
I am running my printer for jewellery purpose. Problem I was facing is my parts were being printed heavier than the required weight. So I had to set msm as minimum as possible i.e. 0.52 which caused the balance to go to 0.95, fade 0.5 and slope 2.05 to get the full platform print with no dropping. I wanted to ask if these extreme settings would be harmful for the projector?

User avatar
mikej
B9 Moderator
B9 Moderator
Posts: 4190
Contact:

Re: Extreme Balance, Fade, Slope, MSM conditions

Post#2 » Sat Dec 03, 2016 10:39 am

No, but I'm actually surprised you are getting results with those extremes. :o
Measure Twice, Cut Once.

Bilal
B9 Maker
B9 Maker
Posts: 23

Re: Extreme Balance, Fade, Slope, MSM conditions

Post#3 » Sun Dec 04, 2016 8:31 am

Is there any other way not to go to these extreme values and get my required weight?
Whenever I reduce the MSM my parts start failing to print specially from the right side of the platform supports doesn't build up. So I have to increase slope

User avatar
Robert Howle
B9 Creator
B9 Creator
Posts: 6627

Re: Extreme Balance, Fade, Slope, MSM conditions

Post#4 » Sun Dec 04, 2016 12:15 pm

What exactly do u mean that u are not getting your "exact weights". PLease explain.

Robert Howle
Dance like nobody's watching!

Bilal
B9 Maker
B9 Maker
Posts: 23

Re: Extreme Balance, Fade, Slope, MSM conditions

Post#5 » Mon Dec 05, 2016 2:22 am

Hello
By this I mean the part which is supposed to be of 10 grams after casting it comes out around 11.5 grams. and for the 50 grams of necklace set it goes to 60 gram which is a big difference.

User avatar
Robert Howle
B9 Creator
B9 Creator
Posts: 6627

Re: Extreme Balance, Fade, Slope, MSM conditions

Post#6 » Mon Dec 05, 2016 2:02 pm

How are u calculating the pre castings estimated weight.

Robert
Dance like nobody's watching!

Return to “Operation”

Who is online

Users browsing this forum: No registered users and 1 guest

Close Menu Shop Forum