Extreme Balance, Fade, Slope, MSM conditions

[Bilal]

Hello
I am running my printer for jewellery purpose. Problem I was facing is my parts were being printed heavier than the required weight. So I had to set msm as minimum as possible i.e. 0.52 which caused the balance to go to 0.95, fade 0.5 and slope 2.05 to get the full platform print with no dropping. I wanted to ask if these extreme settings would be harmful for the projector?

[mikej]

No, but I'm actually surprised you are getting results with those extremes.

[Bilal]

Is there any other way not to go to these extreme values and get my required weight?
Whenever I reduce the MSM my parts start failing to print specially from the right side of the platform supports doesn't build up. So I have to increase slope

[Robert Howle]

What exactly do u mean that u are not getting your "exact weights". PLease explain.

Robert Howle

[Bilal]

Hello
By this I mean the part which is supposed to be of 10 grams after casting it comes out around 11.5 grams. and for the 50 grams of necklace set it goes to 60 gram which is a big difference.

[Robert Howle]

How are u calculating the pre castings estimated weight.

Robert