Delay print and sitting after print

Discussions on normal hardware operation, tips, etc.
Guest

Delay print and sitting after print

Post#1 » Sun Nov 09, 2014 7:47 pm

Hi

I've just started printing and I've noticed that my prints seem to be quite sticky/tacky. I assume this is because they aren't put in the sun quick enough. I work full time so timing my prints is difficult.

This leads me to some questions.
1.
Will not putting the print in uv quick enough make it sticky?

2.
How long can the print hang from the build table?

3.
Is there a way to delay the print job so that I can time it to finish when I want?

thanks in advance.

and how do I change my display name?

User avatar
tim.yoshi
B9 Master
B9 Master
Posts: 822
Contact:

Delay print and sitting after print

Post#2 » Sun Nov 09, 2014 10:50 pm

I haven't noticed problems from leaving prints in printer for prolonged periods. And if your print feel tacky just try water curing method. After cleaning with isopropanol immediately put in the glass jar filled with water. And place all that into UV oven. Yes, in water. You'll notice how dry, clean and "proper" surface will be.
Image

Return to “Operation”

Who is online

Users browsing this forum: No registered users and 1 guest

Close Menu Shop Forum