Table Not Lowering to Zero in Printing

Software issues and solutions
Erinwithans
Lurker
Lurker
Posts: 1

Table Not Lowering to Zero in Printing

Post#1 » Mon Oct 09, 2017 10:27 pm

Hello,

I have a mac running OS 10.12.6 , and version 1.8.6 of the B9 software, on an older 1.1 version of the printer. I've calibrated it several times, and even brought in someone else to help as another set of eyes. When going through the calibration steps, the table is definitely flush with the vat, and the screws tightened into place. However, when it comes to actually print, it doesn't go down as far. I can see it drop a bit from the home position, but not far enough that the initial layer can attach to it. As a result, it doesn't, and I end up with a very well baked thin layer, but nothing else.

Has anyone run into these problems? Any suggestions?

Return to “Troubleshooting”

Who is online

Users browsing this forum: No registered users and 1 guest

cron
Close Menu Shop Forum