I noticed this yesterday when I started a print.
I have been using 1.70 beta software since it was first put out. I haven't upgraded because you don't fix what's not broke.
that being said I am using the 1.1 printer.
I took a video of the arm during a dry run to show what is happening and it's result in failed prints.
When the vat moves from the left to the right the table moves down over the PDMS to position for the next exposure
at that time the arm then moves up slightly and the exposure is opened then the vat moves back to the closed position
as a result each layer is swept away by the wiper and is not adhering to the table.
Now this just started for no apparent reason as I had just printed a small cross flat no supports just two days prior.
any ideas on how to stop the table arm from raising up once it is in the open position or why it is doing this?