Thanks Brumbaer for you advised.

I don't think I able to use any of those settings for the b9 software but I may just prelift higher like 5 mm instead of .30 mm to able to lift up the print off the Fep film.

Mike

Hi Brumbaer That is so cool, Are you able to use any of B9c Resin? What is the setting to make the red plate just to move at beginning and at the end of the print only? You said use 3mm for overlift , what is the others setting that you use like (Pre release lift, Overlift cutoff,Initial Overlift an...

I just tried to replace the lamp but I saw the inner glass broken, can you tell me where I can get the replacement ?

Thanks.
Mike

Hi B9 users Recently I bought 2 liters Green Emerald resins hoping that I wouldn't have to buy Red and Cherry to mix together, but it did not cast as good as the 1:1 Red/Cherry mix. I decided to mix 1/2 of 1:1 Red/Cherry and 1/2 of Green Emerald together and it came out to have a Chocolate color. Th...

What number for Don Corning product should I buy to re seal the glass to the vat ?

Thanks.

Mike

I will go and cut one

Thanks.

I broke my vat's glass , where can I get the replacement ?

Thanks

Mike

Hi Betsy
I just want to buy for big 50 micron build volum but I just change my mind.

Thanks.
Mike

Thanks for your advice.

Mike
Mine art

Thanks
I can not find Dow conrning or Dap adhesive so I bought this instead.
Hope this will work.

Mike.
Mine Art

Hello every One
My both Aluminum vats are rocking so I tried to straighten and the glass lifted off the vat, I would like to know what kind of glue or silicone from Home depot will work ?

Thanks.
Mike
Mine Art

The letters came out perfect. I always have problems with that,
Can you share the trick ?
Thanks
Mike

Hi
Can you post some picture and can you send over to Vancouver.bc. Canada

Mike

Thanks

Hi All
Recently I found out that there are dirt trapped inside the lens,will it effect to the prints and how to clean the lens ?

Thanks.

Mike
Mine Art